NORGLIDE® M Bearings
When bonded to steel, NORGLIDE® MP turns into NORGLIDE® M. Material maintains sizing capability to a large extent with the capability of higher loads.
NORGLIDE® is a composite material of NORGLIDE® MP bearing tape and steel backing. This combination of material improves load capabilities while maintaining the characteristics of NORGLIDE® MP, especially its sizing capability.
The bearings can be designed without play. Bearings of 1 mm wall thickness or greater can be produced with an interference fit in the housing. Various methods are available to protect the steel shell from corrosion.
The standard PTFE compound contains glass fibers and graphite. Special PTFE compounds are available on request. Fabricated parts include rolled bearings with or without an axial flange, deep-drawn bearings and die-cuts. The steel shell and mesh can be offered in stainless steel for chemically-harsh environments.
|Nominal thickness (mm)||Material Structure|
NORGLIDE® M, Type M100GG-2022-B
|Maximum permissible specific bearing load static
--Bearing load dynamic
|Coefficient of friction at RT
--On steel with ≥ 58 HRC
|@ 4.8 MPa and 0.058 m/s
@ 70 MPa and 0.0065 m/s
|Deformation under load||23ºC @ 100 N/mm 2, 1h||≤ 30||micron|
|Coefficient of heat transmission||SG PA 3022||830||W/m2K|
|Operating temperature range||continuous
|-200 to +180
|Coefficient of linear thermal expansion||SG PA 1025||10||10-5/K|
|@ 4.8 N/mm2 and 0.058 m/s
SG PA 1081
||10-6 mm3/ Nm
|Volume resistivity||SG PA 1081||³ 108||Ωcm2|
|Note: This is one example for this type of material design only. Some material properties are dependent from the used PTFE-Compound, the metal type and thickness.|