NORGLIDE® M Bearings
Metal-backed NORGLIDE® MP with maintained sizing capability but applicable for higher loads.
NORGLIDE® M is a composite material of NORGLIDE® MP Bearing tape and steel backing. This combination of material improves load capabilities while maintaining the characteristics of NORGLIDE® MP, especially its sizing capability.
The bearings can be designed without play. Bearings of 1 mm wall thickness or greater can be produced with an interference fit in the housing. Various methods are available to protect the steel shell from corrosion.
Availability
The standard PTFE compound contains glass fibers and graphite. Special PTFE compounds are available on request. Fabricated parts include rolled bearings with or without an axial flange, deep-drawn bearings and die-cuts. The steel shell and mesh can be offered in stainless steel for chemically-harsh environments.
Standard Thickness
NORGLIDE® M-Type
|
||
Nominal thickness (mm) | Material Structure | |
CuSn6 Fabric Steel |
1.4401 Fabric 1.4401 Steel |
|
0.75 | • | |
1.0 | • | |
1.5 | • | |
1.57 | • |
Related Characteristics
NORGLIDE® M, Type M100GG-2022-B
|
|||
Maximum permissible specific bearing load --Static --Dynamic |
220 150 |
MPa |
|
Coefficient of friction at RT
--On steel with ≥ 58 HRC |
@ 4.8 MPa and 0.058 m/s @ 70 MPa and 0.0065 m/s |
0.17 0.09 |
|
Deformation under load | 23ºC @ 100 N/mm 2, 1h | ≤ 30 | micron |
Coefficient of heat transmission | SG PA 3022 | 830 | W/m2K |
Operating temperature range | continuous intermittent |
-200 to +180 260 |
ºC |
Coefficient of linear thermal expansion | SG PA 1025 | 10 | 10-5/K |
K Factor
|
@ 4.8 N/mm2 and 0.058 m/s SG PA 1081 |
0.18 |
10-6 mm3/ Nm |
Volume resistivity | SG PA 1081 | ³ 108 | Ωcm2 |
Note: This is one example for this type of material design only. Some material properties are dependent from the used PTFE-Compound, the metal type and thickness. |
Find out about NORGLIDE® SMTL.